Cleaning Instructions
Direct Application (Pump Sprayer / Electric or Air Diaphragm System):
Dilute product as needed (5:1 to 20:1).
Spray on surface.
Allow to dwell 2–15 minutes.
Agitate heavily soiled areas (175 floor tool recommended).
Surface clean and rinse. (Hot water preferred, cold water acceptable.)
Downstream Application:
Use a downstream injector that delivers the correct dilution.
Spray, dwell 2–15 minutes, agitate as needed.
Surface clean and rinse.
X-Jet Application:
Pre-dilute to match desired ratio.
Spray, dwell 2–15 minutes, agitate if needed.
Surface clean and rinse.
Neutralizing Use
General Neutralizing: Dilute 8:1. Spray on surface, broom in if needed, then rinse.
Adjust dilution strength up or down to ensure wastewater discharge meets local pH BMP requirements.
Neutralizes:
Rust remover residues (F9 BARC, F9 Efflo)
Battery acid (sulfuric)
Hydrocarbons, oils, tire marks, food stains, and more